MaxFit Standard Adjustable Men's Traction Extender

Before every session, confirm that:

• The device and silicone loop are clean and undamaged.
• You are fully awake, sober and able to monitor sensation.
• The device is being fitted while fully flaccid.
• Both rods are configured and adjusted evenly.
• The retention loop is secure but not painfully tight.
• The skin remains warm, normally colored and fully sensitive.
• You can remove the device immediately if necessary.

Stop use immediately if you experience pain, burning, pinching, coldness, numbness, loss of sensation, unusual swelling or blue, white or dark discoloration.

Do not resume until all symptoms have fully resolved. If symptoms persist, worsen or repeatedly return, seek advice from a qualified healthcare professional before using the device again.

For adult use only. Use the MaxFit Standard Edition only as described in the supplied instructions and do not modify the device or combine it with unapproved parts.

Temporary light pressure marks can occur at contact points, but pain, persistent redness, coldness, numbness, unusual swelling, blue or pale discoloration are not signs to ignore. Remove the device immediately if any of these occur.

There is no fixed timeline. Individual experience depends on anatomy, fit, adjustment level, routine and consistency. Avoid increasing tension simply to pursue faster changes.There is no fixed timeline. Individual experience depends on anatomy, fit, adjustment level, routine and consistency. Avoid increasing tension simply to pursue faster changes.

No. Use only the components required for the current setup. Begin with the shortest practical configuration and add length progressively.

No. The Standard Edition should only be used while awake and able to monitor fit, circulation, sensation and device position.

After becoming familiar with the device, it may be worn under loose clothing during low-movement activities. Clothing must not press the rods into the body, change the device angle or prevent regular comfort checks.

Do not apply lotion, oil or petroleum-based products before use. They can make the retention loop slip and may interfere with secure positioning. If the skin feels dry, apply an appropriate moisturizer after the session and allow it to absorb fully before the next use.

Remove it instead of tightening it aggressively. Make sure the skin and silicone components are clean and completely dry, confirm the loop is correctly installed and check that the selected rod configuration is not creating excessive tension.

No. A new user should begin with low tension while learning the correct fit. Stronger tension is not automatically better and can make it harder to maintain a safe, consistent routine.

The loop-style system can generally be fitted by either circumcised or uncircumcised adults. Uncircumcised users should make sure the foreskin is positioned comfortably and is not pinched, folded tightly or pulled unevenly by the loop.

Clean the body-contact components before and after every use.

• Wash detachable silicone parts with lukewarm water and mild, fragrance-free soap.
• Rinse away all soap residue.
• Wipe the frame, rods and adjustment components with a clean damp cloth.
• Dry every component thoroughly before reassembly or storage.
• Do not store the device while damp.
• Do not use bleach, strong alcohol, abrasive cleaners or aggressive solvents.
• Do not apply oil, petroleum jelly, body lotion or powder immediately before use, as these products can make the retention components slip.
• Keep threaded rods free from dirt, dried soap and fibers.
• Store the device in a clean, dry place away from direct sunlight and excessive heat.
• Inspect the silicone loop regularly and replace it if it develops cuts, thinning, permanent stretching or surface damage.

1. Inspect the deviceCheck the frame, threaded rods, adjustment nuts, silicone loop and contact surfaces before every session. Do not use the device if any part is cracked, distorted or damaged.
2. Select the correct support sizeConfirm that the M or L opening provides comfortable clearance before adding tension.
3. Begin with the shortest practical rod configurationUse the shortest configuration that allows the device to be positioned correctly. Additional rod length should be introduced gradually rather than installed all at once.
4. Prepare the retention loopMake sure the soft silicone loop is correctly seated and free from twists, cuts or damage. The loop should be secure but should not create painful compression.
5. Apply only while fully flaccidGuide the penis through the base opening while the device is compressed. Position the glans support and silicone retention loop according to the included assembly guide.
6. Secure the loop gentlyTighten the loop only enough to prevent slipping. Excessive fastening can restrict circulation and cause discomfort, numbness or discoloration.
7. Release the device slowlyAllow the rods to extend gradually. Adjust both sides evenly so the device remains balanced rather than pulling more strongly on one side.
8. Start with low tensionThe first sessions are for learning the fit and checking comfort. Do not begin with maximum rod length or aggressive tension.
9. Perform an early comfort checkCheck the device after the first few minutes. The skin should remain warm, normally colored and fully sensitive.
10. Take regular breaksAs a cautious routine, remove the device after approximately 60–90 minutes and take a 15-minute break. Recheck the skin and circulation before continuing.
11. Remove it if an erection occursThe Standard Edition should be fitted while fully flaccid. If an erection develops, remove the device and wait until fully flaccid before reapplying it.

The size refers to the support opening, not the extension-rod length.

• Size M support opening: 46 × 39 mm
• Size L support opening: 58 × 48 mm

Choose M if the smaller opening provides comfortable clearance and stable support without pinching.

Choose L if you need more room through the support opening, have broader anatomy or fall between the two sizes.

The correct size should feel supportive without creating sharp pressure around the base. Do not force yourself through an opening that feels too small. If you are uncertain between M and L, the larger opening is generally the more forgiving starting choice.

Extension length is adjusted separately through the rod configuration and should not be used to compensate for an incorrectly sized support opening.

The Standard Edition is best used during quiet, low-movement activities when you can check the fit regularly.

Suitable situations may include:

• Reading or watching television at home.
• Private desk work with sufficient room to sit comfortably.
• Short, supervised familiarization sessions.
• A scheduled routine in which you can remove the device and take regular breaks.

Once you are familiar with the fit, it may be possible to wear the device under loose clothing. Avoid tight trousers that press the device against the body or prevent you from checking its position.

Do not wear it while sleeping. Sleep prevents regular circulation and comfort checks and makes it harder to respond quickly if the device shifts.

Do not use the device if you cannot comfortably monitor pressure, sensation, skin color and device position during the entire session.

Do not use it:

• On broken, irritated, inflamed or infected skin.
• If there is existing pain, numbness, unusual swelling or discoloration.
• While under the influence of alcohol, sedatives, narcotics, sleeping medication or anything that reduces pain awareness.
• During sleep, exercise, sexual activity or other strenuous movement.
• While driving, operating machinery or performing activities with a significant risk of falling.
• With parts that are cracked, damaged, sharply worn or incorrectly assembled.
• Together with unapproved replacement parts or improvised weights.

Ask a qualified healthcare professional before use if you have recently undergone surgery, have reduced sensation, use a penile implant, or have a known condition involving the penis, testicles, urethra, circulation, veins or connective tissue.

The MaxFit Standard Edition is designed for adults who want a straightforward, manually adjustable traction system without an oversized accessory set.

It is especially suitable for:

• First-time extender users who prefer a simpler assembly process.
• Buyers who want fewer components to organize, clean and maintain.
• Users who prefer a soft silicone retention loop instead of a multi-point support cradle.
• Buyers who want a choice of four colors: Black, White, Red or Blue.
• Users who want to build a private, gradual routine at home.
• Buyers looking for the most accessible entry point in the MaxFit collection.

Choose the Deluxe or Premium Edition instead if you specifically want a multi-point support cradle, additional comfort components or a larger extension component set.